The protection in circuits with 230V must be more noteworthy than 2MO. (صيانة ميكروويف دايو)
I fixed the connectors and cleaned them with liquor.
Repairing a consumed electronic board
I likewise cleaned that territory of ??the circuit, which recently was not available with the connectors.
Repairing a consumed electronic board
I welded them again and estimated once more. On this event, the obstruction was more noteworthy than 2MO, in light of the fact that the multimeter
was not equipped for estimating it.
One less issue.
Scratching with the tweezers, I disposed of the veneer from the closures of the cut copper tracks, to almost certainly weld them.
Repairing a consumed electronic board
As of now it is a great idea to apply a little tin on uncovered copper, to encourage welding.
Mystery weapon
As I referenced in 12 motivations to take photos of your repairs , I have a photographic record of a significant number of the repairs I
have made.
For this situation, this plate had just gone through my hands at different occasions, so I had a pleasant image of the copper
tracks when they were still entirety.
On the off chance that I had not had the picture, my second alternative would have been to look for another indistinguishable plate. This machine has three
or on the other hand four equivalent plates.
Since it had a tremendous opening, the base for the triac was negligible, so I chose to utilize its very own pins as help and track at
a similar time.
By collapsing the pins, and slicing them to estimate, I welded them specifically onto the welds of alternate parts.
Before mounting the triac, I had set the warmth sink with warm silicone, and its relating bolt.
Repairing a consumed electronic board
I repaired the cut copper track by making a scaffold with a bit of tinned wire.
The focal stick of the triac ought to be joined to two tracks, on the off chance that you look at the picture you will see that it is associated
to an upper and lower track. http://daewoo-repair.com/
The stick is twisted up, and there was some space to the base, so I connected a decent drop of tin.
On the off chance that you are bad at "chiseling" with tin, you can utilize a bit of wire, or a bit of opposition stick.
Remember that tin has a low dissolving point, so in the event that you have made an exceptionally slight scaffold, it can liquefy more effectively than
copper.
I connected greater amount, in spite of the fact that it isn't so stylish (great time to consider feel, with a consumed and penetrated
plate).
When you connect a track with string, ensure it has a bigger area.
For this situation, the circuit has 6 amp breakers, so the link must be bigger than the wire.
Repairing a consumed electronic board
As I didn't have breakers of a similar size, I changed the circuit holders to other standard 5x20mm.
This change must not be made at extremely high voltages , on the grounds that the protection voltage is reduced.
The last test
When mounting the plate on the machine, it began to fill in as though nothing had occurred.
However something had changed: I was somewhat more joyful ??
Since these are the moments that give us life, when we believe we have conquered the test, and a plate has endure
because of our intervention.
It's your turn
Have you at any point confronted any consumed plaque?
How have you tackled it?
Do you additionally feel upbeat when you see a machine working once more, or am I the just one and would it be a good idea for me to make it look?(صيانة غسالات دايو)
No comments:
Post a Comment